How to Install the Basin Water Pop Up?

March 27, 2019

People's daily cleanliness can not be separated from the basin, but they want to discharge the waste water in the basin. It is inseparable from the basin water filter. The basin water device is a drainage device installed in the basin sewer, etc. It exists to ensure the basin's Normal use. Next, Xiao Bian will explain to you how to install the basin of water into the water and other related knowledge, learn it together.

pop up waste

Basin classification of water pipes

1, press-type water device

Although the appearance of the push-type discharge device looks good, the press-type discharge water is more likely to adhere to some dirt. The entire discharge device needs to be screwed off to perform thorough cleaning, and the operation will be slightly complicated, and it is not very convenient to use. If the water filter is unscrewed, the safety may be loosened and not firm.

2, flip type water device

The flap launcher can be rotated in any direction, resulting in water leakage in the basin. After a long time, the flap type popper will have a reduced sealability, which will make it impossible for the basin to contain water. Or the situation that it does not turn over; flip-type water absorber is simple in structure, easy to clean, and easy to replace.

3, the drain water device

The structure of the drain trap is also relatively simple. It is almost the same as the kitchen sink. The assembly and disassembly procedures of the drain trap are slightly more complicated than the installation of the press-type pop-up device and the flap-type pop-up device. The sink drain basin cannot hold water unless it is sealed.

black pop up waste

Basin water dispenser installation procedure

1, first come up with the purchase of the water dispenser, the lower part of the basin into the water fixture and the flange open, and then the basin flange of the water pipe tightly buckled under the basin, we must put the flange tight, After the tightening, you can put the basin on the top of the table, and one end of the basin's water pipe is aligned with the hole on the top of the basin.

2, in the appropriate position of the basin under the water pipe wrapped in some anti-seepage of the tape, and then the other end of the basin water pipe at the sewer, which is the sewage drainage pipe at the hole, to adjust the basin water pipe accessories or Take out the parts and use a wrench to tighten the interface between the lower water dispenser and the sewer pipe. After the installation is completed, check whether the two ends of the basin water pipe are evenly adjusted and tightened.

3. Check if there are no parts or flats in the installation process. After checking that there are no errors, the water inside the basin starts to be tested and the water is leaked from the side. If there is no water leakage or water seepage, it means that the plumbing under the basin is installed; otherwise, you need to recheck or reinstall it.

문의하기

Author:

Ms. linly

이메일:

464021406@qq.com

Phone/WhatsApp:

+8613751081118